Pdl setting parameters, Next – Kyocera FS-C1020MFP User Manual
Page 352
Top Page
>
Configuring the Machine Using the Control Panel
> PDL Setting Parameters
PDL Setting Parameters
This section describes the PDL setting parameters.
Paper Input
●
Tray Priority
Specifies the tray that the machine checks first for paper that matches the print.
[Tray2] appears only when it is installed.
Default: [Tray1]
❍
Tray1
❍
Tray2
List Print
Prints lists showing configurations on the machine.
●
Configuration Page
Prints general information and the current configurations of the machine.
●
Menu List
Prints the machine's function menus.
●
Test Page
Prints a test page to check the current color settings.
●
PCL Font List
Prints installed PCL font list.
●
PS Font List
Prints installed PostScript font list.
System
●
Copies
Sets the machine to print the specified number of sets.
This setting is disabled if the number of pages to print is specified by the printer driver.
Default: 1
❍
1 to 999, in increments of 1
●
Sub Paper Size
Sets the machine to print onto paper of another size if the specified paper is not loaded in any
tray. Alternative sizes are preset to A4 and Letter.
Default: [Off]
❍
On
❍
Off
●
Default Paper Size
Specifies the paper size to be used when the paper size is not specified in the print job.
Default:
Letter (8
1
/
2
” × 11”),
A4
❍
A4, B5 JIS, A5, B6-S, A6, Legal, Letter, Half Letter-S, Executive, 8 Ч 13, 8.5 Ч 13, Folio,
16K, Com 10, Monarch, C5 Env, C6 Env, DL Env
Contents