Kyocera FS-C1020MFP - Manual (Page 447)

Top Page > Maintenance > Cleaning > Cleaning the Registration Roller
Cleaning the Registration Roller
The registration roller can become dirty with paper dust if you print to non-standard paper.
Clean the registration roller if white dots appear on prints.
●
Unplug the power cord from the wall outlet before you move the machine. While moving the machine, you
should take care that the power cord will not be damaged under the machine.
●
The inside of this machine becomes very hot. Do not touch parts labelled “ ” (indicating a hot surface).
●
Do not use chemical cleaning fluids or organic solvents such as thinner or benzine.
●
Do not touch the transcription roller (the white area in the illustration below).
Turn off the power.
Unplug the power cord from the wall outlet. Remove all the cables from the machine.
Pull the opening lever on the front cover, and then carefully lower the front cover.
Be sure to set the registration roller in the position shown by the arrow in the illustration below.
Contents Previous Next Settings