Next – Kyocera FS-C1020MFP User Manual
Page 456
Top Page
>
If the Machine is Not Going to Be Used for a Long Time
> Preparing the Machine for a Long Period of Inactivity
Preparing the Machine for a Long Period of Inactivity
Use this procedure to prepare the machine for a long period of inactivity with its power switch turned off.
Note that not using the following procedure could result in unusual noises when use of this machine is
resumed.
●
Do not switch off the machine during printing.
Turn off the power switch.
Pull out the plug from the socket.
Pull Front Cover Open Lever, and then open the front cover with both hands carefully.
Lower the blue fusing unit lever.
Using a coin, turn both gray knobs on the fusing unit 90 degrees counterclockwise (until
the slots are horizontally aligned with the marking shown in the illustration below).
Close the front cover with both hands carefully.
Contents