Kyocera FS-C1020MFP - Manual (Page 313)

Top Page > Configuring the Machine Using the Control Panel > Fax Transmission Settings > Fax Transmission Setting Parameters
Fax Transmission Setting Parameters
This section describes fax transmission setting parameters.
Immediate TX
Sets the machine to send a fax immediately when the original is scanned.
Default: [Off]
●
Off
Select this when using Memory Transmission.
●
On
Select this when using Immediate Transmission.
●
Next Fax Only
Select this when using Immediate Transmission for the next transmission only.
Resolution
Specifies the resolution to use for scanning originals.
Default: [Standard]
●
Standard
Select this when the original is a printed or typewritten document with normal-sized
characters.
●
Fine
Select this when the original is a document with small print.
●
Photo
Select this when the original contains images such as photographs or shaded drawings.
Density
Specifies the image density to use for scanning originals.
Default: [Normal]
●
Light
●
Normal
●
Dark
Pause Key Time
Specifies the length of pause time when a pause is inserted between the digits of a fax number.
Default: 3 seconds
●
1 to 15 seconds, in 1 second increments
Auto Redial
Sets the machine to redial the fax destination automatically when the line is busy or a transmission
error occurs, if the machine is in Memory Transmission mode. The number of redial attempts is
preset to two or three times, depending on the [Country Code] setting under [Admin Settings], in
five-minute intervals.
Default: [On]
●
Off
●
On
Contents Previous Next Settings