Kyocera FS-C1020MFP - Manual (Page 317)

Top Page > Configuring the Machine Using the Control Panel > Fax System Settings > Fax System Setting Parameters
Fax System Setting Parameters
This section describes fax system setting parameters.
RX Settings (Reception Settings)
Specifies the settings for receiving a fax.
●
RX Mode
Specifies the reception mode.
Default: [Fax Only]
❍
Fax Only
The machine automatically answers all incoming calls in fax reception mode.
❍
Manual
The machine rings when it receives incoming calls. The machine receives faxes only
when you manually receive faxes.
❍
FAX/TAD
The machine receives faxes automatically when a fax call is received. Otherwise, the
connected telephone answering device answers the call.
❍
FAX/TEL
The machine receives faxes automatically when a fax call is received. Otherwise, the
machine starts to ring.
●
Auto Reduction
Sets the machine to reduce the size of a received fax if it is too large to print on a single sheet
of paper.
Note that the machine only reduces the size down to 74%. If further reduction is required to
fit the fax on a single sheet, it will be printed on separate sheets without being reduced.
Default: [On]
(Default may be [Off] depending on the [Country Code] setting under [Admin Settings].)
❍
Off
❍
On
●
Ring Count Delay
Specifies the number of times the machine rings before it starts to receive faxes in Fax Only
mode.
Default: 3 times
❍
3 to 5 times, in increments of 1
●
F/T Ring Time
Specifies the length of time the machine tries to detect the fax calling tone in FAX/TEL mode.
Default: 15 seconds
❍
5 to 99 seconds, 1 second increments
Tray Settings
●
Tray Use: Fax
Specifies the tray for printing received faxes. Note that only A4, Letter, or Legal size paper can
be used for printing faxes. Make sure to select a tray that contains paper of the valid size.
If tray 2 is not installed, only [Tray1 Only] appears.
Default: [Auto]
❍
Auto
Contents Previous Next Settings