Kyocera FS-C1020MFP - Manual (Page 429)

M toner Independent-supply
A non-supported print cartridge is
installed.
Contact your service representative.
Near End X Toner The print cartridge is almost empty. Prepare a new print cartridge.
Near End Waste Toner Bottle The waste toner bottle is almost full. Prepare a new waste toner bottle.
Near Memory Full
Memory has almost reached capacity
during sort copy.
If several originals are still to be scanned, it
is recommended to start printing now, and
copy the remaining originals separately. If
originals are being scanned from the ADF,
remove any remaining pages from the ADF.
Net Communication Error
Press Clear Key
Connection with the server was lost
while sending or receiving data.
Contact the network administrator.
Network Is Not Ready Press
Clear Key
A scanned file could not be sent
because the machine has not
received IP address information from
the DHCP server completely.
Wait until the machine receives the IP
address information completely, and then
try the operation again.
No Profile Exist
No Quick Dial entry is associated
with the One Touch button you
pressed.
●
Press a different One Touch button.
●
Assign a registered destination to
the One Touch button. See
Registering Scan Destinations .
Outer Jam
Paper has been jammed in the
machine.
Remove the jammed paper. See Removing
Printing Jams .
Please Reboot System
An error occurred and the machine
cannot continue to operate.
Turn off the power, and then turn it back
on.
Print JOB
Memory OverFlow
When performing printing on Legal
size paper under certain print quality
setting, print data becomes large and
the job may be canceled.
If using the PCL printer driver, set
[Gradation] in [Print Quality] to [Speed] or
[Standard]. If using the PostScript 3 printer
driver, set [Print Quality] in [Printer
Features] to [Standard] or [High Quality].
RX Comm. Error
A reception error occurred, and the
fax could not be received correctly.
If possible, contact the sender of the fax
and ask them to resend it.
Scan Network Disconnect
Press Clear Key
A scanned file could not be sent
because the Ethernet cable was not
connected properly.
Reconnect the Ethernet cable properly, and
then try the operation again.
Scan USB Disconnect
The USB cable was disconnected
while scanning from a computer.
Reconnect the USB cable properly, and
then try the operation again.
Server Connection Failed
Press Clear Key
A scanned file could not be sent
because the destination could not be
reached.
Confirm that the destination is registered
correctly, and then try the operation again.
Server Response Error Press
Clear Key
An error occurred in communication
with the server before beginning
transmission.
Confirm that the destination is registered
correctly, and then try the operation again.
If the problem could not be solved, contact
the network administrator.
Service call - X
A fatal hardware error has occurred,
and the machine cannot function.
Contact your service representative.