Vaisala Hydromet Data Collection Platform - Manual (Page 139)

Chapter 4 ________________________________________________ Configuring Telemetry Options
VAISALA______________________________________________________________________ 137
Dial
The Dial parameter is used as a prefix for the destination number when
making the call. Any acceptable AT commands and options can be
used.
For example, the format for the Dial parameter is the following:
ATX1DT123456
The destination number is set with the station settings through the
service interface either by entering value for the at_dial parameter in the
Station settings window in the terminal software or with the spset
command in the service connection. The format for the spset command
is:
spset at_dial "123456"
Disconnect
The Disconnect parameter is sent to the modem when closing the line
after a completed or failed transmission. Usually this parameter consists
of the control sequence +++ followed by the ATH command for
hanging up.
Shutdown
The Shutdown parameter is optional and may be required by certain
modems before the modem power is switched off. This parameter is
only used when the modem is powered through the excitation pin.
where
ATX1DT
= Dial string
123456 = Destination number, which can be saved as a static
parameter at_dial . The number should be given
separately for each report that is sent
NOTE Always use quotation marks around the phone number when setting
the value with the station settings.