Figure 26 – Vaisala Hydromet Data Collection Platform User Manual
Page 67
Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA_______________________________________________________________________ 65
You can also select the communication timeout in the Polling mode and
the Cyclic Transmit mode; see
.
0711-133
Figure 26
Measurements View: Configuring Weather
Transmitter Timeout Parameters
With the Polled mode timeout parameter you can define the maximum
length of time allowed for the weather transmitter to reply.
With the communication timeout parameters in Cyclic transmit mode,
you can define a maximum interval between two messages. If the new
message from the transmitter has not been received within the given
time, the data in that message is then marked as invalid.
Using Sensor Variables in Reports
You can use the variables received from the weather transmitter in
Lizard Setup Software like those from any other sensor.
To check which variables are available, proceed as follows:
1.
Select the Reports view; see
2.
Create a new report or select an existing one to include the
variables for weather transmitter WXT520.
3.
Click WXT520_1 in the Available list box in the Select variables
frame.