Vaisala Hydromet Data Collection Platform - Manual (Page 148)

User's Guide ______________________________________________________________________
146 _________________________________________________________________ M210933EN-C
It is recommended that you use the Station setting parameter because
it provides the possibility to change the destination without changing
the setup. The Station setting parameters can be set using either of the
following:
1. With the terminal software Station settings window.
2. With the spset <param> <value> command in the service
connection.
PSTN-Dependent Configurations
The modem control can only use data calls for transferring the reports
over the public telephone network (PSTN).
0711-159 Figure 70 PSTN Transmission Configuration Options
Transmission Mode
The Transmission mode parameter allows selection between the two
modes:
1. Data call: The report is automatically sent to the destination by
making a call. The report can also be polled, if the Poll command
is defined.
2. Polled only: The report is only sent when polled by the remote
system.
NOTE Always use quotation marks around the parameter value for
destination. For example: spset sms_to "0401234567"