Vaisala Hydromet Data Collection Platform - Manual (Page 246)

User's Guide ______________________________________________________________________
244 _________________________________________________________________ M210933EN-C
Built-in defaults for the field formats are composed as follows:
1. Use default subject:
- The message subject follows the format
<source name> <station name> YYMMDDhhmmss where
- Source name is the name of the message content source,
typically a report
- Station name is the name of the weather station
- YYMMDDhhmmss is a time stamp
2. Use sname@domain as sender:
- The first part of the sender identity is the weather station
name, followed by the @ sign and the source domain as set in
the general SMTP client configuration. For example:
[email protected]
- When this option is selected, the other parameters must be
configured as follows:
- The Source domain parameter must be configured in the
general SMTP client configuration in the IP Services
view
- The Sender parameter can be left empty in the e-mail
message configuration in the Communications view
Automatic and Timed Transmission of E-Mail Messages
By default, messages are sent immediately when created, and multiple
reports per one SMTP session will be sent only if they are created at the
same time.
If buffering messages is required to, for example, reduce
communication costs or preserve power, multiple messages can be sent
during one SMTP session using a timer. The E-mail Transmit timer for
the SMTP client component is configurable in the setup but disabled by
default. To enable this mode of operation, proceed as follows:
1. In the Communications view, select the option Send only when
timed for the report(s) you want to send based on the timer.
2. In the Timers view, set the desired transmission interval for the
SMTP client component's E-mail Transmit timer.