Vaisala Hydromet Data Collection Platform - Manual (Page 81)

Chapter 3 _____________________________________________ Configuring Modules and Sensors
VAISALA_______________________________________________________________________ 79
Temperature Measurement PT1000
With the QML logger, you can measure Pt1000 elements. In the
Equipment view, select the sensor from the Available list and connect
the sensor to the desired connector, see
Figure 36 on page 79 .
0711-143 Figure 36 Equipment View: Selecting I/O Connections for
PT1000
By default, the Pt1000 measurement is a 3-wire connection but you can
change it to a 4-wire connection on the Advanced user level by
changing the measurement type. Typically, you do not need to change
the predefined Pt1000 parameters. Only the data validation parameters
can vary, depending on the installation site. You can see all parameters
as an Advanced user.
See Chapter 7, Technical Data, on page 337 for the example wiring
diagrams for 3-wire and 4-wire connections of the Pt1000 probe.