INFICON XTC/3 Thin Film Deposition Controller Operating Manual - Manual (Page 129)

5 - 17
PN
07
4-
44
6-
P1
J
XTC/3 Operating Manual
33 Crystal Switching
34 Crucible Switcher Fail
35 Shutter Delay Error
36 Computer Control
37 Crucible Select Source 1 Binary (8 outputs required, one/position)*
38 (Crucible Select Source 1 Binary, bit 2)
39 (Crucible Select Source 1 Binary, bit 3)
40 (Crucible Select Source 1 Binary, bit 4)
41 (Crucible Select Source 1 Binary, bit 5)
42 (Crucible Select Source 1 Binary, bit 6)
43 (Crucible Select Source 1 Binary, bit 7)
44 (Crucible Select Source 1 Binary, bit 8)
45 Crucible Select Source 1 BCD (3 outputs required BCD)*
46 (Crucible Select Source 1 BCD, bit 2)
47 (Crucible Select Source 1 BCD, bit 3)
48 Crucible Select Source 2 Binary (8 outputs required, one/position)*
49 (Crucible Select Source 2 Binary, bit 2)
50 (Crucible Select Source 2 Binary, bit 3)
51 (Crucible Select Source 2 Binary, bit 4)
52 (Crucible Select Source 2 Binary, bit 5)
53 (Crucible Select Source 2 Binary, bit 6)
54 (Crucible Select Source 2 Binary, bit 7)
55 (Crucible Select Source 2 Binary, bit 8)
56 Crucible Select Source 2 BCD (3 outputs required BCD)*
57 (Crucible Select Source 2 BCD, bit 2)
58 (Crucible Select Source 2 BCD, bit 3)
* Querying an output that corresponds to a secondary bit of one of the crucible
select will return the corresponding number. For individual updates, only the
primary bit can be set. The corresponding secondary bits will be set automatically.
For a block update (UO 255 or UB x, see below), when a Crucible Select is set, the
primary bit must be set. Each additional bit corresponding to the Crucible Select
must have the proper corresponding number, or 0.