INFICON XTC/3 Thin Film Deposition Controller Operating Manual - Manual (Page 28)

1 - 12
PN
07
4-
44
6-
P1
J
XTC/3 Operating Manual
1.5 Unpacking and Inspection
1 If XTC/3 control module has not been removed from its shipping container,
do so now.
2 Carefully examine the control module for damage that may have occurred
during shipping. This is especially important if you notice obvious rough
handling on the outside of the container. Immediately report any damage to the
carrier and to INFICON.
3 Do not discard the packing materials until you have taken inventory and have
at least performed a power-on verification.
4 Take an inventory of your order by referring to your order invoice and the
information contained in
section 1.6 on page 1-12 .
5 To perform a power-on verification (see section 1.7 on page 1-16 ).
6 For additional information or technical assistance, contact INFICON
(refer to
section 1.3 on page 1-5 ).
1.6 Parts and Options Overview
1.6.1 Base Configurations
XTC/3M Control Unit for nom. 120 V (ac) . . . . . PN XC3M-1xxx
XTC/3M Control Unit for nom. 230 V (ac) . . . . . PN XC3M-2xxx
XTC/3S Control Unit for nom. 120 V (ac). . . . . . PN XC3S-1xxx
XTC/3S Control Unit for nom. 230 V (ac). . . . . . PN XC3S-2xxx
Technical Manual . . . . . . . . . . . . . . . . . . . . . . . . PN 074-446 on 074-5000-G1 CD
Handheld Power Controller . . . . . . . . . . . . . . . . PN 755-262-G1, Optional
Ship Kit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PN 780-603-G1 (120 V (ac)) or
PN 780-603-G2 (230 V (ac))