3 displays – INFICON XTC/3 Thin Film Deposition Controller Operating Manual User Manual
Page 50
3 - 4
PN
07
4-
44
6-
P1
J
XTC/3 Operating Manual
3.3 Displays
Seven XTC/3 display screens are used for monitoring
and programming processes:
Operate
Film Parameter
Process List (XTC/3M only)
General Parameter
I/O Map
Diagnostics
Sensor
To maximize the life of the display, it can be set to dim after a period of 1 to 99
minutes without a key press (see
section 4.4.2, Hardware Parameters, on page
, parameter LCD DIMMER TIME).
Pressing a key before the dimmer time elapses resets the dimmer interval
to start over.
The default setting of 0 disables the dimmer function.
When the display is dimmed, its brightness will be
bright if a film is running
dark if a film is not running (as in Ready or Idle).
All keys remain active. To restore the display to full brightness without inadvertently
changing parameters, press either HELP: or
◄
or
►
.