INFICON Cygnus 2 Thin Film Deposition Controller - Manual (Page 23)

1 - 5
IP
N 07
4-
54
5-
P1
E
Cygnus 2 Operating Manual
1.2.4 Main Power Connection
WARNING - Risk Of Electric Shock
This Cygnus 2 has line voltage present on the primary
circuits whenever it is plugged into a main power source.
Never remove the covers from the Cygnus 2 during
normal operation.
There are no operator-serviceable items within the
Cygnus 2.
Removal of the top or bottom covers must be done only
by a technically qualified person.
In order to comply with accepted safety standards, the
Cygnus 2 must be installed into a rack system which
contains a mains switch. This switch must break both
sides of the line when it is open and it must not
disconnect the safety ground.