INFICON Cygnus 2 Thin Film Deposition Controller - Manual (Page 53)

3 - 3
IP
N 07
4-
54
5-
P1
E
Cygnus 2 Operating Manual
3.2 Rear Panel Interfaces
Interfaces for the Cygnus 2 are located on the rear panel, see Figure 3-2 .
Figure 3-2 Cygnus 2 rear panel
1 Ground Stud
Refer to section 2.2.2, Connections to Earth Ground, on page 2-5 .
2 AC Power Inlet, Fuse & Mains Switch
Provides main power switch, fuse and common connector for international plug
sets.
3 8 Relay x 14 Input I/O Card (standard)
Provides pin connection for 8 Relays rated for 30 V (dc) or
30 V (ac) RMS or 42 V (peak) maximum, and 14 TTL inputs.
4 8 Relay x 14 Input I/O Card (optional)
Provides pin connection for 8 relays rated for 30 V (dc) or
30 V (ac) RMS or 42 V (peak) maximum, and 14 TTL inputs.
5 8 Relay x 14 Output I/O Card (optional)
Provides pin connection for 8 relays rated for 30 V (dc) or 30 V (ac) RMS or
42 V (peak) maximum, and 14 open collector type outputs.
6 Sensor Connectors - Channels 1 & 2 (standard)
Provides connection for two Sensor channels
7 Sensor Connectors - Channels 3 & 4 (optional)
Expansion panel to accommodate the optional addition of two more sensors,
Sensors 3 & 4.
1 2 3 9 4 5 6 7 8 10 11 12
15 14 13