Rockwell Automation 1756-CFM ControlLogix Configurable Flowmeter Module - Manual (Page 117)

117 Rockwell Automation Publication 1756-UM010B-EN-P - December 2011
Troubleshooting the Configurable Flowmeter Module 117
Using RSLogix 5000
Software to Troubleshoot
Your Module
In addition to the LED display on the module, RSLogix 5000 software will
alert you to fault conditions. You will be alerted in one of four ways:
 Warning signal on the main screen next to the module-This occurs
when the connection to the module is broken
 Fault message in a screen’s status line
 Notification in the Tag Editor - General module faults are also reported
in the Tag Editor. Diagnostic faults are only reported in the Tag Editor
 Status on the Module Info Page
The screens below display fault notification in RSLogix 5000 software.
Warning icon when a
communications fault occurs
or if the module is inhibited
Notification in Tag Editor
A value of 1 shows a fault for this
input point.
Fault message in status line
Warning signal on main screen
Warning signal - The module in slot 1 has a communications fault
Status line provides information on
the connection to the module
Status section lists Major and
Minor Faults and the Internal
State of the module
!
!