Rockwell Automation 1756-CFM ControlLogix Configurable Flowmeter Module - Manual (Page 76)

76 Rockwell Automation Publication 1756-UM010B-EN-P - December 2011
76 Installing the Configurable Flowmeter Module
Removing the Module
1. Push in the locking tabs.
2. Pull the module out of the chassis.
WARNING
!
When you insert or remove the module while backplane
power is on, an electrical arc can occur. This could cause an
explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding. Repeated electrical arcing causes
excessive wear to contacts on both the module and its
mating connector. Worn contacts may create electrical
resistance that can affect module operation.
20856–M
20857–M