Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 100)

10-2 Setting Up Allen-Bradley Ethernet to RIO Block Transfer Pass Thru Communications
Figure 10.1 shows an example:
Figure 10.1
Allen-Bradley Ethernet Communications
Hardware Required Hardware
The hardware required for this type of communications depends on the drive
type. Refer to the following table:
SCANport-
Compatible
Product
1395
Drive
1336
FORCE
Drive
PLC-5E
RIO
Ethernet
Ethernet
Important: In the Remote I/O
communications module, Switch 1 of SW3
must be On to enable block transfer.
Drive Required Drive Hardware Required Computer Hardware
SCANport Product
➀ Remote I/O adapter (1203-GD1,
1203-GK1, or 1336-GM1) and
appropriate cable(s) Ethernet Interface Running TCP/IP
Protocol
1336 FORCE PLC Communications Board
(1336T-GT1EN) Ethernet Interface Running TCP/IP
Protocol
1395 Node Adapter (1395-KP50) or
Multi-Communications Adapter
(1395-KP51) Ethernet Interface Running TCP/IP
Protocol
➀
For a list of SCANport-compatible products, refer to Appendix A, Products Supported by DriveTools32.