Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 114)

11-8 Using RSLinx Gateways
4. Click OK. One of the following occurs:
5. If you are using RIO block transfer pass thru communications, you must
type the rack number and group number in the appropriate fields, and then
click OK. In addition, you must ensure that block transfer has been enabled
in the end device.
The DriveTools32 application is now communicating with the drive. If you are
prompted to create a new database, click Yes.
Important: If a prompt appears to alert you that the application failed to
communicate with the drive, refer to Chapter 16, Troubleshooting.
Result Action
Connected to a drive You are ready to use the DriveTools32
application
Connect to Drive dialog box
reappears You are using RIO block transfer pass
thru communications. Go to Step 5.