Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 69)

Setting Up ControlNet Direct Communications 7-9
Configuring RSLinx
For RS-232 to ControlNet communications, you must configure RSLinx for
RS-232 serial communications.
Important: When configuring a driver for RS-232 to ControlNet, you should
select the KFC 1.5 card in the Device field of the following RSLinx dialog box.
Refer to the “Configuring RSLinx” section in Chapter 3, Setting Up RS-232
Point-to-Point Serial Communications, for instructions on configuring RSLinx.
Select
KFC 1.5