Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 70)

7-10 Setting Up ControlNet Direct Communications
Setting Up Communications in a DriveTools32 Application
Before a DriveTools32 application can communicate with a drive, you must
configure the application. To do this, you need to:
1. Start the DriveTools32 application.
2. In the Options menu, select Communication Setup. The Communication
Setup dialog box appears.
3. Click the ControlNet tab.
4. Under Connect Type, select KFC to ControlNet Phase 1.5 Direct.
5. In the Enter INTERCHANGE Port Mapping # field, type the number of
the KT:0 port used by the ControlNet driver in the RSLinx Configure
Client Applications dialog box.
Important: To view the KT Port number used by the DF1 driver, select
Configure Client Applications in the RSLinx Communications menu.
6. If you are using a 1336 FORCE and its drive firmware version is 0.10,
select 1336T Two Word Header (used ONLY for 1336T version 0.10).
7. Click OK.