Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 112)

11-6 Using RSLinx Gateways
Setting Up
Communications
in a DriveTools32
Application Before a DriveTools32 application can communicate with a drive, you must
configure the application. To do so, you need to:
1. Start the DriveTools32 application.
2. In the Options menu, select Communication Setup. The Communication
Setup dialog box appears.
3. Click the RSLinx Gateway tab.
4. Under Connect Type, select the appropriate communications type.
If your Gateway is to: Select:
ControlNet To ControlNet Direct
DH+ Direct To DH+ Direct
DH+ to RIO Block Transfer Pass Thru To DH+ to PLC RIO Pass-Thru
Serial To RS-232 SCANport Point to Point Serial