Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED User Manual
Page 81
Setting Up ControlNet to RIO Block Transfer Pass Thru Communications
8-9
2.
In the Options menu, select Communication Setup. The Communication
Setup dialog box appears.
3.
Click the ControlNet tab.
4.
Under Connect Type, select KFC to ControlNet Phase 1.5 to PLC RIO
Pass-Thru.
5.
In the Enter INTERCHANGE Port Mapping field, type the number of
the KT:0 port used by the ControlNet driver in the RSLinx Configure
Client Applications dialog box.
Important: To view the KT Port number used by the ControlNet driver, select
Configure Client Applications in the RSLinx Communications menu.
6.
If you are using a 1336 FORCE and its drive firmware version is 0.10,
select 1336T Two Word Header (used ONLY for 1336T version 0.10).
7.
Click OK. The following prompt appears.
8.
Read the information, and then click OK to save the configuration.