Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 52)

6-2 Setting Up DH+ to RIO Block Transfer Pass Thru Communications
Figure 6.1 shows an example:
Figure 6.1
DH+ to RIO Block Transfer Pass Thru Network
How you set up the hardware and configure RSLinx and DriveTools32 for DH+
to RIO block transfer pass thru communications depends on whether you are
using an internal interface card or external converter.
PLC-5
Important: In the Remote I/O
communications module, Switch 1 of SW3
must be On to enable block transfer.
SCANport-
Compatible
Product
1395
Drive
1336
FORCE
Drive
DH+
RIO
Computer with
1770-KF2
Converter Computer with
Internal Card
OR
Using: Communications Refer To:
Internal Interface Card
(1784-KT, -KTX, -KTXD, -PCMK) DH+ to RIO Block Transfer
Pass Thru “Using DH+ to RIO Block Transfer Pass
Thru Communications” on page 6-3
External Converter
(1770-KF2) RS-232 Serial to DH+ to RIO
Block Transfer Pass Thru “Using RS-232 to DH+ to RIO Block
Transfer Pass Thru Communications” on
page 6-7