Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 55)

Setting Up DH+ to RIO Block Transfer Pass Thru Communications 6-5
5. In the Enter INTERCHANGE Port Mapping # field, type the number of
the KT:0 port used by the DH+ driver in the RSLinx Configure Client
Applications dialog box.
Important: To view the KT Port number used by the DH+ driver, select
Configure Client Applications in the RSLinx Communications menu.
6. If you are using a 1336 FORCE and its drive firmware version is 0.10,
select 1336T Two Word Header (used ONLY for 1336T version 0.10).
7. Click OK. The following prompt appears.
8. Read the information, and then click OK.
Connecting to the Drive
After configuring RSLinx and the DriveTools32 application, you are ready to
connect to a drive.
1. In the Drive menu, select Connect to Drive. The RIO Pass Through
Network Connect to Drive dialog box appears.