Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 139)

Using ControlLogix Gateway to RIO Block Transfer Pass Thru Communications 14-5
5. In the Enter INTERCHANGE Port Mapping # field, type the number of
the KT:0 port used by the driver in the RSLinx Configure Client
Applications dialog box.
Important: To view the KT Port number used by the shortcut, select Configure
Client Applications in the RSLinx Communications menu.
6. If you are connecting via more than one backplane, type the number in the
Enter the total number of the ControlLogix in Shortcut field. This field
appears only if you have selected Multiple ControlLogix Gateway.
7. If you are using a 1336 FORCE and its drive firmware version is 0.10,
select 1336T Two Word Header (used ONLY for 1336T version 0.10).
8. Click OK to save the configuration. A DriveTools32 message appears.
9. Read the message, and then click OK.
Connecting to the
Drive After configuring RSLinx and the DriveTools32 application, you are ready to
connect to a drive.
1. In the Drive menu, select Connect to Drive. The ControlLogix Gateway
Connect to Drive dialog box appears.