Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 65)

Setting Up ControlNet Direct Communications 7-5
7. Click OK to configure the driver. The new driver appears in the Configure
Drivers dialog box.
8. Click Close.
Mapping the Configured Driver to the KTPort Value
After configuring the driver, you must map it to a legacy INTERCHANGE API
xKT:0 label in RSLinx. To map the configured driver, you need to:
1. In the Communications menu, select Configure Client Applications. The
Configure Client Applications dialog box appears.
2. In an unused KT:0 field, select the ControlNet driver.
Important: Note the KT:0 field that you select. When you configure a
DriveTools32 application, you need to enter the field number in the
Communication Setup dialog box.
3. Click OK.