Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 105)

Setting Up Allen-Bradley Ethernet to RIO Block Transfer Pass Thru Communications 10-7
4. Under Connect Type, select Allen-Bradley Ethernet to PLC (SLC) with
RIO pass-thru.
Important: If you are running DriveMonitor32, you can access a PLC by
selecting Allen-Bradley Ethernet Direct to PLC.
5. In the Enter IP Address field, type the same IP address entered in the
Configure driver for Ethernet to PLC-5 or 5820 dialog box.
6. If you are using a 1336 FORCE and its drive firmware version is 0.10,
select 1336T Two Word Header (used ONLY for 1336T version 0.10).
7. Click OK. The following prompt appears.
8. Read the information, and then click OK.
Connecting to the
Drive After configuring RSLinx and the DriveTools32 application, you are ready to
connect to a drive.
1. In the Drive menu, select Connect to Drive. The Ethernet Connect to
Drive dialog box appears.
2. In the Enter Drive Rack # field, type the RIO rack number of the drive.
The rack number is specified in octal and is set in the communications
module.