Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 74)

8-2 Setting Up ControlNet to RIO Block Transfer Pass Thru Communications
Figure 8.1 shows an example:
Figure 8.1
ControlNet to RIO Block Transfer Pass Thru Network
How you set up the hardware and configure RSLinx and DriveTools32 for
ControlNet to RIO Block Transfer Pass Thru communications depends on
whether you are using an internal interface card or external converter.
PLC-5C
Important: In your RIO communications
module, Switch 1 of SW3 must be On to
enable block transfer.
SCANport-
Compatible
Drive
1395 1336
FORCE
ControlNet
Channel A
RIO
Computer with
1770-KFC
Converter
OR
Computer with
Internal
Interface Card
Channel B
Using: Communications Refer To:
Internal Interface Card
(1784-KTC, -KTCX, -PCC) ControlNet to RIO Block
Transfer Pass Thru “Using ControlNet to RIO Block Transfer
Pass Thru Communications” on page 8-3
External Converter
(1770-KFC) RS-232 Serial to ControlNet
to RIO Block Transfer Pass
Thru “Using RS-232 to ControlNet to RIO Block
Transfer Pass Thru Communications” on
page 8-7