Rockwell Automation 9303 DRIVE TOOLS 32 VER 2.50 GETTING STARTED - Manual (Page 126)

13-2 Using ControlLogix Gateways
Figure 13.1 shows an example:
Figure 13.1
ControlLogix Gateway Connection
Hardware Required Hardware
The hardware required for this type of communications depends on the drive
type. Refer to the following table:
SCANport-
Compatible
Product
1395
Drive
1336
FORCE
Drive
1203-GK5
Ethernet
ControlNet
DeviceNet
ControlLogix
1203-GK5
ControlLogix
Backplane 1
Backplane 2
Drive Required Drive Hardware Required Computer Hardware
SCANport-Compatible
➀ ➁ ➂
1336 FORCE ➁ ➂
1395 ➁ ➂
➀
For a list of SCANport-compatible products, refer to Appendix A, Products Supported by DriveTools32.
➁
You need the hardware that connects your drive to the network. Refer to the chapter in this manual which
describes the network that you are using.
➁
The equipment that is required depends on the communications that you are using. If you are using
Ethernet communications, you will need an interface running TCP/IP. If you are using ControlNet, you will
need a 1784-KTC, 1784-KTCX, 1784-PCC, or 1770-KFC adapter.