Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 128)

5-14 LiquiFlo 1.5 AC Drive, Software Reference Version 1.2
5.5 Test Point Codes and Functions
Table 5.7 – Fault Names Cross-Referenced by Fault Number
No. 1
1 Fault numbers not listed are reserved for future use.
Fault No. 1 Fault No 1 Fault
2 Function Loss 38 Phase U to Grnd 80 AutoTune Aborted
3 Power Loss 39 Phase V to Grnd 81-
86 Port 1-6 DPI Loss
4 UnderVoltage 40 Phase W to Grnd 100 Parameter Chksum
5 OverVoltage 41 Phase UV Short 101 UserSet1 Chksum
7 Motor Overload 42 Phase VW Short 102 UserSet2 Chksum
8 Heatsink OvrTemp 43 Phase UW Short 103 UserSet3 Chksum
9 Trnsistr OvrTemp 48 Params Defaulted 104 Pwr Brd Chksum1
12 HW OverCurrent 63 Shear Pin 105 Pwr Brd Chksum2
13 Ground Fault 64 Drive Overload 106 Incompat MCB-PB
24 Decel Inhibit 69 DB Resistance 107 Replaced MCB-PB
25 OverSpeed Limit 70 Power Unit 108 Anlg Cal Chksum
29 Analog In Loss 71-76 Port 1-6 Net Loss 120 I/O Board Mismatch
33 Auto Rstrt Tries 77 IR Volts Range 121 I/O Board Comm
Loss
36 SW OverCurrent 78 FluxAmpsRef Rang 122 I/O Board Fail
37 Phase Imbalance 79 Excessive Load 207 Gate Kill
Table 5.8 – Test Point Codes and Functions
Code Selected in Testpoint x
Sel (234, 236)
Function Whose Value is Displayed in
Testpoint x Data (235, 237)
1 DPI Error Status
2 Heatsink Temperature
3 Active Current Limit
4 Active PWM Frequency
5
Lifetime MegaWatt Hours
1
1 Use the equatio n below to calculate total Lifetime MegaWatt Hours.
6 Lifetime Run Time
7 Lifetime Powered Up Time
8 Lifetime Power Cycles
9
Life MegaWatt Hours Fraction
(1)
10
Life MegaWatt Hours Fraction Units
(1)
11-99 Reserved for Factory Use
Value of Code 9
Value of Code 10
------------------------------------------ 0.1
×
 
 
Value of Code 5 + Total Lifetime Megawatt Hours =