Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 7)

Contents V
List of Tables
Table 1.1 – Quickstart Parameters ........................................................................... 1-3
Table 2.1 – Key Functions ........................................................................................ 2-4
Table 2.2 – How to Adjust Each Parameter Type..................................................... 2-7
Table 4.1 – Default Values for Preset Speeds 1-7 ................................................. 4-23
Table 4.2 – Analog Output Scaling ......................................................................... 4-73
Table 4.3 – Speed Select Inputs............................................................................. 4-75
Table 4.4 – Default Values for Parameters 361-366 .............................................. 4-75
Table 4.5 – Drive Response to Jog Forward and Jog Reverse Inputs ................... 4-77
Table 4.6 – Effect of Speed Select Input State on Selected Reference ................. 4-78
Table 5.1 – Ready LED Status Definitions ............................................................... 5-2
Table 5.2 – Types of Alarms..................................................................................... 5-3
Table 5.3 – Alarm Descriptions ................................................................................ 5-4
Table 5.4 – Alarm Names Cross-Referenced by Alarm Numbers ............................ 5-5
Table 5.5 – Fault Types ............................................................................................ 5-6
Table 5.6 – Fault Descriptions and Corrective Actions ............................................ 5-9
Table 5.7 – Fault Names Cross-Referenced by Fault Number............................... 5-13
Table 5.8 – Test Point Codes and Functions.......................................................... 5-13
Table 5.9 – Drive Does Not Start From Start, Run, or Jog Inputs Wired to the
Terminal Block ................................................................................... 5-14
Table 5.10 – Drive Does Not Start or Jog From OIM ............................................. 5-15
Table 5.11 – Drive Does Not Respond to Changes in Speed Command .............. 5-16
Table 5.12 – Motor and/or Drive Will Not Accelerate to Commanded Speed ........ 5-16
Table 5.13 – Motor Operation is Unstable .............................................................. 5-17
Table 5.14 – Drive Will Not Reverse Motor Direction ............................................. 5-17
Table 5.15 – Stopping the Drive Results in a Decel Inhibit Fault............................ 5-17
Table 5.16 – OIM Cables........................................................................................ 5-18