Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 41)

Parameter Descriptions 4-9
This parameter is not used with LiquiFlo 1.5 AC drives. Displays a fault from the
rectifier.
Set to match the type of motor connected; Induction, Synchronous Reluctance, or
Synchronous Permanent Magnet.
Set to the motor nameplate rated volts. The motor nameplate base voltage defines the
output voltage when operating at rated current, rated speed, and rated temperature.
Set to the motor nameplate rated full load amps. The motor nameplate FLA defines
the output amps when operating at rated voltage, rated speed, and rated temperature.
It is used in the motor thermal overload and in the calculation of slip.
35 Rectifier Fault
Range: 0 to 299
Default: Read Only
Access: 1 Path: Monitor>Application
See also:
40 Motor Type
Range: 0 = Induction
1 = Synchr Reluc
2 = Synchr PM
Default: 0 = Induction
Access: 1 Path: Motor Control>Motor Data
See also:
41 Motor NP Volts
Range: 0.0 to Drive Rated Volts [0.1 VAC]
Default: Based on Drive Type
Access: 0 Path: Motor Control>Motor Data
See also:
42 Motor NP FLA
Range: 0.0 to Rated Amps x 2 [0.1 Amps]
Default: Based on Drive Type
Access: 0 Path: Motor Control>Motor Data
See also: 47, 48