Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 23)

Using the LCD OIM 2-11
Select from the list of preconfigured functions:
Undefined (default)
Load User Set 1-3: Loads the specified user set into active drive memory. The drive
responds as if a value had been entered in Load Frm User Set (198), or Load Frm Usr
Set was selected from the OIM’s Memory Storage menu.
Save User Set 1-3: Saves the active configuration to drive memory. The drive
responds as if a value had been entered in Save to User Set (199) or Save to User Set
was selected from the OIM’s Memory Storage menu.
Acc/Dec Change: Toggles between the display of Acc/Dec rate 1 and Acc/Dec rate 2
(The value the drive is configured to go to, not the current value being used by the
drive). This selection is based on the active value of the rate parameters (140-143).
Therefore, when any of these parameters change, the actual acc/dec rates will
dynamically change.
Preset Speed 1-6: Toggles the selected preset speed on and off and grants Hand
(manual) reference control. Returns to Auto reference when the function is toggled.
View Fault Queue: Displays the Fault Queue screen (see chapter 12). Press to
return to the process display screen.
Next: (Reserved for future use.)
!
ATTENTION:Loading a user set with LevelSense Start (168) set to
Enable can result in the drive starting immediately when all start
conditions are met.
When this function is enabled, the user must ensure that automatic start
up of the driven equipment will not cause injury to operating personnel
or damage to the driven equipment. In addition, the user is responsible
for providing suitable audible or visual alarms or other devices to indicate
that this function is enabled and the drive may start at any moment.
Failure to observe this precaution could result in severe bodily injury or
loss of life.
ESC/
PROG