Rockwell Automation Liqui-Flo 1.5 General Purpose and Vector Duty - Manual (Page 25)

Using the LCD OIM 2-13
2.8 Controlling the Drive From the LCD OIM
When the OIM is the selected control source, it can be used to control the drive:
• Start (Run)
• Stop
• Clear Faults
2.8.1 Starting the Drive
When the OIM is the selected control source, pressing issues a start command
to the drive.
2.8.2 Stopping the Drive
Pressing will issue a stop command to the drive.
Important: Stop commands from any attached OIM will always be enabled.
Figure 2.11 – Selecting Reverse Video for the Process Display Screen
P0: LiquiFlo 1.5
Auto Stopped
Fltq
0.00 Volts
Amps
Hz
0.00
0.00
Luse1
Normal Video Reverse Video
P0: LiquiFlo 1.5
Auto Stopped
Fltq
0.0
0
Volt
s
Amp
s
Hz
0.0
0
0.0
0
Luse1