Rockwell Automation FlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board - Manual (Page 15)

Installation 2-1
C
HAPTER
2
Installation
This section describes how to install the Network Option board in the FlexPak 3000 or
WebPak 3000 drive and connect the drive to an AutoMax network.
2.1 Installing the Network Option Board
To install the Network Option board:
Step 1. Turn off, lock out, and tag all incoming power to the drive.
Step 2. Loosen the two (2) captive screws on the drive cover. Remove the cover.
Step 3. Loosen the captive screw on the carrier. Swing open the carrier. See figure 2.1.
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, or service this equipment. Read and
understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.
ATTENTION: The user is responsible for conforming with all applicable
local, national, and international codes. Wiring practices, grounding,
disconnects, and overcurrent protection are particularly important. Failure
to observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: Do not install modification boards with power applied to
the drive. Disconnect and lock out incoming power before attempting
such installation. Failure to observe this precaution could result in severe
bodily injury or loss of life.
Figure 2.1 – Removing Drive Cover
Loosen Captive Screw
and Swing Carrier Open