Rockwell Automation FlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board - Manual (Page 45)

F
lex
Pak
3000 Drives
: O
rig
inal Regist
er
M
a
p
5-
15
22 Stop cause word Bit-packed word indicating why the drive stopped
0 Stop asserted or Run de-asserted (negated)
1 Jog de-asserted for less than 1 second
2 Internal stop request
3 Current limit stop
4 Ramp stop
5 Coast/DB stop
6 Fault stop or self-tuning complete
7 Customer interlock opened
8 Coast/DB interlock opened
9 Main contactor opened
10 – 15 Reserved
23 NOMINAL AC LINE FREQ (P.306) Nominal AC line frequency Hz
24 NOMINAL AC LINE VOLTS (P.307) Nominal AC line RMS voltage volts RMS
25 PLL MAXIMUM ERROR (P.308) Max. allowed change in line period per AC line cycle µsec
26 AC LINE VOLTAGE (P.392) Measured AC line RMS voltage volts RMS
27 ENHANCED FLD VOLT ADJ (P.500) Adjusts the field output voltage
28 FIELD ECONOMY DELAY (P.501) Time between stopping and entering field economy minutes
29 FIELD ECONOMY ACTIVE (P.599) Indicates the present state of field economy 0= OFF ; 1= ON (field economy active)
30 OPEN SCR SENSITIVITY (P.600) Open SCR detection sensitivity adjustment
31 OPEN SCR TRIP THRESH (P.601) Open SCR detection trip threshold
Table 5.16 – FlexPak 3000 Original Register Map, Drop_4: Master Read Registers, FULL Connection. Tunable, Configurable, and Status Data (Drive Output Data) (Continued)
Register Bit Parameter Name (Number) Description Settings
Tunable, configurable and status data are updated by the regulator approximately every 600 msec.