Figure 2.2 - removing the carrier shield, Figure 2.3 - removing shield ground wire – Rockwell Automation FlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board User Manual
Page 16
Advertising
2-2
AutoMax Network Communication Option Board
Step 4.
Remove the screws that attach the carrier shield to the carrier. See
figure 2.2.
Step 5.
Remove the connector that attaches the shield ground wire to the drive
power supply. Set the shield aside. See figure 2.3.
Step 6.
Position the Network Option board over the standoffs. Refer to figure 2.4.
Step 7.
Secure the Network Option board using three captive screws on the board.
Step 8.
Plug the option board ribbon cable into the Network Option board.
Figure 2.2 – Removing the Carrier Shield
Figure 2.3 – Removing Shield Ground Wire
Carrier Shield
Ground Wire
Power Supply
Advertising