Rockwell Automation FlexPak/WebPak 3000 DC Drive AutoMax Network Communication Board - Manual (Page 30)

4-8 AutoMax Network Communication Option Board
4.11 Parameters That Are Only Available in the FlexPak
Alternate Register Map
4.12 Settings for Analog and Frequency Outputs
These are the options you can set for the I/O Expansion kit analog and frequency
output parameters.
Same for WebPak?
RAMP STOP DECEL TIME (P.018)
STOP DECEL SELECT (P.122)
NEG CUR LIM INV EN (P.226)
CML REF LIMIT SELECT (P.311)
INV FAULT AVOID SEL (P.312)
DIG IN 0 SELECT (P.428)
TACH LOSS SCR ANGLE (P.608)
PHASE LOSS DETECT (P.609)
OCL PROP TRIM SELECT (P.813)
OCL TYPE 3 POSN REG EN (P.814)
NETW REGISTER MAP SEL (P.914)
SPD LOOP PI INIT SEL
SPD LOOP PI INIT VAL
SPD LOOP PI RESET
UNDERWIND ENABLE
Process Error Parameter Number
0= CML FEEDBACK (P.397)
1= CML REFERENCE (P.396)
2= CML ERROR (P.398)
3= SPD LOOP FEEDBACK (P.296)
4= SPD LOOP REFERENCE (P.295)
5= SPD LOOP ERROR (P.297)
6= SPD LOOP OUTPUT (P.299)
7= SPEED RAMP OUTPUT (P.199)
8= SPEED RAMP INPUT TP (P.198)
9= SPD SOURCE SELECT OUT (P.193)
10= TRIM OUTPUT (P.197)
11= ARMATURE VOLTAGE (P.289)
12= ANALOG TACH FEEDBACK (P.291)
13= PULSE TACH FEEDBACK (P.292)
14= ZERO
15= FULL SCALE
16= POWER OUTPUT
17= OCL REFERENCE (P.845)
18= OCL RAMP OUTPUT (P.846)
19= OCL FEEDBACK (P.847)
20= OCL OUTPUT (P.848)
21= FIELD REFERENCE (P.590)
22= FIELD FEEDBACK (P.589)
23= NETW IN REG 1 (P.905)
24= NETW IN REG 2 (P.906)
25= NETW IN REG 3 (P.907)