Metrohm tiamo 1.1 Manual - Manual (Page 227)

Report templates 199
Autoscaling
[ on ], off
If this option is enabled then all the axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be ed-
ited.
Quantity
Command-dependent selection
Selection of the quantity to be shown on the y1 axis.
Label
50 characters, [ auto ]
Freely definable axis labeling for the y1 axis. With auto the name from the
Quantity will be used.
Scaling
Start value
1 E-8 ... [ 0.0 ] ... 1 E+8
Initial value for scaling the y1-axis.
End value
1 E-8 ... [ 1000.0 ] ... 1 E+8
Final value for scaling the y1-axis.
Curve
Curve color
Color selection, [ blue ]
Selection of the color for the curve line.
Symbol
Symbol selection, [ no symbol ]
Selection of the symbol for showing the measured values. With no symbol
the measuring points will not be shown.
Symbol color
Color selection, [ blue ]
Selection of the color for the measuring point symbol.
Smoothing
on, [ off ]
Switches smoothing on/off for the curve.
Smoothing factor x axis
[ 0.01] ... 1000
Factor for smoothing on the x-axis.
Smoothing factor y axis
[ 0.01] ... 1000
Factor for smoothing on the y-axis.
Display original curve as well
on, [ off ]
If this option is enabled then in addition to the smoothed curve the original
curve will also be shown (dotted, same color).