Metrohm tiamo 1.1 Manual - Manual (Page 738)

710 Configuration
Terminator for receive
20 characters, \0D, \0D\0A, \0D\0A\0A, \0D\0D\0A ( \0D = CR, \0A = LF)
Final character for reception in hexadecimal code.
Code page
[ Cp437 ], Cp850, Cp851
Code page used for the data transmission.
Send characters one by one
on, [ off ]
If this option is enabled every character is sent separately. Before sending
the next character, the
Delay time is waited for.
Delay time
[ 0 ] ... 9000 ms
Waiting time before sending the next character.
Tests the connection to the device. The dialog window Check connection
appears.
Test connection
In order to test the connection to a generic RS232 device the device must be se-
lected in the Device table and then under
Edit, Properties the Properties window for
this device is opened. On the tab RS 232 the button [Check connection] must then
be pressed.
Opens the dialog window Check connection .
The messages sent to and received by the device are shown in the large
text field.
Sends the message entered in the field to the left of the button to the de-
vice.