Metrohm tiamo 1.1 Manual - Manual (Page 52)

24 General program functions
Identifier Description Commands
.BLV Blank value of the sensor used for the command (for
ISE sensors only) or the blank value calculated during
calibration (for CAL LOOP Conc)
DET U, MET U, SET U,
STAT U, MEAS U, MEAS
Conc, CAL LOOP Conc,
DOS U
.BP{#}.DME Difference in measured values for break point # (1...9) MET
.BP{#}.ERC ERC or 1st derivative for break point # (1...9) DET
.BP{#}.MEA Measured value for break point # (1...9) in the units of
the measured value DET, MET, MEAS (with-
out T/Flow)
.BP{#}.TEM Temperature for break point # (1...9) in °C DET, MET, MEAS (with-
out T/Flow)
.BP{#}.TIM Time for break point # (1...9) in s DET, MET, MEAS (with-
out T/Flow)
.BP{#}.VOL Volume at break point # (1...9) in mL DET, MET
.BSY Command status; 1 = BUSY, HOLD or ERROR;
0 = READY; invalid (variable not present) = Com-
mand has never been started All except START and
END
.CBY Command status; 1 = conditioning active,
0 = conditioning not active SET, KFT, KFC
.COK Command status; 1 = conditioning criterion ful-
filled, 0 = conditioning criterion not fulfilled SET, KFT, KFC
.CONC Concentration of the solution used for the command DET, MET, SET, KFT,
STAT, ADD, DOS, LQH,
STDADD
.CYL Cylinder volume of the exchange or dosing unit used
for the command DET, MET, SET, KFT,
STAT, STDADD dos,
STDADD auto, ADD,
DOS, LQH, PREP,
EMPTY
.DBL Total duration for processing the command in s DET, MET, SET, KFT,
KFC, STAT, MEAS, CAL
MEAS, STDADD, DOS
.DRI Current or last drift for drift correction in µL/min SET, KFT, KFC
.DSC Duration for processing all start conditions in s DET, MET, SET, KFT,
STAT
.DTI Time for the drift correction (time from start of titration
until end of command) in s
SET, KFT, KFC
.EGF Last measured gas flow (measured value after proc-
essing the command) in mL/min MEAS T/FLow
.EME Final measured value (measured value after process-
ing the command) in the units of the measured value
DET, MET, SET, KFT,
KFC, STAT, MEAS, CAL
MEAS, STDADD, DOS
.ENP Electrode zero point of the sensor used for the com-
mand (dimensionless for pH sensor or in mV for ISE
sensor) or the electrode zero point calculated from the
calibration (for CAL LOOP)
DET pH, DET U, MET
pH, MET U, SET pH,
SET U, STAT, MEAS pH,
MEAS U, MEAS T, MEAS
Conc, STDADD, CAL
LOOP, DOS
.EP{#}.DME Difference in measured values for end point # (1...9) MET