Metrohm tiamo 1.1 Manual - Manual (Page 721)

Subwindow Devices 693
Device type
Shows the type of device.
Program version
Shows the program version of the device.
Opens the dialog window Load new program version . This button is only ac-
tive when the device has an old program version that is not supported by
tiamo which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the device
table.
Working hours
Shows the number of operating hours (only for 778, 789, 814, 815, and 855
devices).
Data storage under legal control
on, [ off ]
This option must be enabled if the balance has its own data memory (only
for Sartorius balances).
Remarks
1000 characters, [ empty ]
Remarks about the device.
This button is only shown with a balance or barcode reader. In order to de-
lete the device from the device list the device must be disconnected.
Load new program version
If when a device is connected up it is discovered that this has an old program ver-
sion that is not supported by tiamo then it must be updated. This is done by se-
lecting the device in the Device table and using
Edit, Properties to open the Proper-
ties window for the device. On the tab General the button [Update] is then active.
Opens the dialog window Load new program version .
Old version
Shows the old device program version.
New version
Shows the new device program version to be loaded.
Loads new program version.
Note
Make sure that the device is not manipulated or switched off during the loading
process and follow the instructions shown.