Metrohm tiamo 1.1 Manual - Manual (Page 55)

Formula editor 27
Identifier Description Commands
.MA.VOL Volume for maximum measured value in mL DET, MET, SET, KFT,
STAT
.MI.GFL Minimum gas flow in mL/min MEAS T/Flow
.MI.MEA Minimum measured value in the units of the measured
value DET, MET, SET, KFT,
STAT, MEAS
.MI.TEM Temperature for minimum measured value in °C DET, MET, SET, KFT,
STAT, MEAS
.MI.TIM Time for minimum measured value in s DET, MET, SET, KFT,
STAT, MEAS
.MI.VOL Volume for minimum measured value in mL DET, MET, SET, KFT,
STAT
.MR.MRC Correlation coefficient for mean dosing rate for whole
range STAT, DOS
.MR.MRS Standard deviation für mean dosing rate for whole
range in mL/min STAT, DOS
.MR.MRT Mean dosing rate for whole range in mL/min STAT, DOS
.MTE Temperature measurement with sensor; 1 = on,
0 = off) DET, MET, SET, KFT,
STAT, MEAS (without
T/Flow), CAL MEAS,
STDADD, DOS
.NMP Number of measuring points in list of measuring points DET, MET, SET, KFT,
KFC, STAT, MEAS, CAL
MEAS, DOS
.RAN Current absolute shift angle of the rack in ° referred to
the axis of the selected tower (entry at end of com-
mand)
MOVE
.RE{x}.DRC Correlation coefficient for mean dosing rate in window
x (1...9)
STAT
.RE{x}.DRS Standard deviation for mean dosing rate in window x
(1...9) in mL/min STAT
.RE{x}.DRT Mean dosing rate in window x (1...9) in mL/min STAT
.RE{x}.RWL Lower limit of evaluation window x (1...9) in s STAT
.RE{x}.RWH Upper limit of evaluation window x (1...9) in s STAT
.RES Calculated result for standard addition in selected unit STDADD
.RPO Current rack position (entry at end of command);
0 means 'not defined'
MOVE
.SAN Current absolute swing angle of the swing head in °
(entry at end of command) MOVE, SWING
.SLO Electrode slope of the sensor used for the command
(in % for pH sensor or mV for ISE sensor) or the elec-
trode slope calculated from the calibration (for
STDADD and CAL LOOP) DET pH, DET U, MET
pH, MET U, SET pH,
SET U, STAT, MEAS pH,
MEAS U, MEAS T, MEAS
Conc, STDADD, CAL
LOOP, DOS
.SME Starting measured value (measured value after proc-
essing the start conditions) in the units of the meas-
ured value
DET, MET, SET, KFT,
KFC, STAT