Metrohm tiamo 1.1 Manual User Manual
Page 802
774
How to proceed
Modify statistics
Note
The tab
Statistics
will only be shown when the last determination (and only this
one) is selected from a set of determinations which, because of the statistics de-
fined in the method, belong together.
5. Open
tab
Statistics
.
6.
In the field
Result name
, select the result whose
Result value
is to be displayed.
7.
Select desired determination whose result value(s) should be switched on or off
for the statistics.
8.
If only the selected result of the determination has to be switched on or off for the
statistics, click on
[Result on/off]
.
9.
If all results of the selected determination have to be switched on or off for the sta-
tistics, click on
[Determination on/off]
.
Note
If the results of a determination are switched off then when this determination is
recalculated the statistics for these results will be switched off, i.e. no data for
the mean value and standard deviations will be shown. However, the determina-
tions remain statistically linked to each other so that the results can also be
switched on again.
10. Click
on
[Recalculate]
.
The selected determinations are recalculated. The results of this recalculation are
entered automatically in the subwindow
Result view
.
11. In
the
Reprocessing
window, click on
[OK]
.
Each determination that has been modified by reprocessing will be saved as a
new version with a version number increased by
+1
and the subwindow
Reproc-
essing
will be closed. This button is inactive when the recalculation has not yet
been triggered and if not all the selected determinations could be reprocessed.
Edit curve evaluation
Note
The tab
Curve evaluation
is only shown when a single determination that contains
curves that can be evaluated has been selected.
5. Open
tab
Curve evaluation
.
6.
In the field
Command name
, select the command whose curve is to be displayed.
7. Click
on
[Edit]
.
The window
Curve evaluation
for manually reprocessing the curve evaluation
opens.
8.
Modify the curve evaluation manually and close window with
[OK]
.
9. Click
on
[Recalculate]
.
The selected determinations are recalculated. The results of this recalculation are
entered automatically in the subwindow
Result view
.