Metrohm tiamo 1.1 Manual - Manual (Page 344)

316 Method
Note
The selected workplace view will only be opened when starting a single deter-
mination or starting the first determination of a series. It won't be opened when a
new method within a determination series is being loaded.
Track view for live window
Live display 1
[ Main track ], Selection from available tracks
Selection of the track to be displayed in the subwindow Live display 1 .
Live display 2
[ Main track ], Selection from available tracks
Selection of the track to be displayed in the subwindow Live display 2 .
Statistics
on, [ off ]
The statistics defined in the CALC command are only calculated if this pa-
rameter is switched on.
Note
In order that the statistics is calculated it must be switched on in the Workplace
as well.
Number of single determinations
1 ... 99, [ not defined ]
The number of single determinations defined here is valid for all CALC
commands in the method. When not defined is selected, the number of sin-
gle determinations must be defined in the Workplace.
Conditioning
Automatic conditioning
[ on ], off
If this parameter is enabled, the conditioning will be started automatically
at the start of a determination for the all commands with activated condi-
tioning (
SET , KFT , KFC ). After the track including the command with condi-
tioning has been finished, the conditioning is started again and will be con-
tinued even at the end of the determination.
If this parameter is disabled, the conditioning won't be started until the start
of the command with the conditioning. The conditioning isn't started again
after the track including the command with conditioning has been finished.
This parameter must be switched off for automation applications.