Metrohm tiamo 1.1 Manual - Manual (Page 54)

26 General program functions
Identifier Description Commands
.IGF Initial gas flow (measured value at start of command)
in mL/min
MEAS T/Flow
.IME Initial measured value (measured value before proc-
essing the start condition) in the units of the measured
value DET, MET, SET, KFT,
STAT, MEAS, CAL
MEAS, STDADD, DOS
.ITE Initial temperature (temperature before processing the
start conditions) in °C
DET, MET, SET, KFT,
STAT, MEAS (without
T/Flow), CAL MEAS,
STDADD, DOS
.LCO Loop counter = current number of completed loops
both for Repeat and While loops LOOP, CAL LOOP
.LP.CAx Calculated value x (1...3) for the last measuring point DET, MET, SET, KFT,
KFC, STAT, MEAS, DOS
.LP.CHA Charge for last measuring point in mA·s KFC
.LP.DME Difference in measured values for last measuring point MET
.LP.DVT dV/dt for the last measuring point (SET, KFT, STAT,
DOS) or drift for last measuring point in µg/min (KFC)
SET, KFT, KFC, STAT,
DOS
.LP.ERC ERC for last measuring point DET
.LP.EXx External value x (1...3) for last measuring point DET, MET, SET, KFT,
KFC, STAT, MEAS, DOS
.LP.GFL Gas flow value for last measuring point in mL/min MEAS T/Flow
.LP.IGE Current pulse current for last measuring point in mA KFC
.LP.MEA Measured value for last measuring point in the units of
the measured value DET, MET, SET, KFT,
KFC, STAT, MEAS, CAL
MEAS, DOS
.LP.QTY Measured value (water) for last measuring point in µg KFC
.LP.TEM Temperature for last measuring point in °C DET, MET, SET, KFT,
STAT, MEAS, CAL
MEAS, DOS
.LP.TIM Time for reaching last measuring point in s DET, MET, SET, KFT,
KFC, STAT, MEAS, CAL
MEAS, DOS
.LP.UGE Potential at generator electrode for last measuring
point; 0 = not defined, 1 = <14 V, 2 = 14...28 V,
3 = >28 V KFC
.LP.VOL Volume for last measuring point in mL DET, MET, SET, KFT,
STAT, DOS
.LPO Current absolute lift position in mm (entry at end of
command) LIFT
.LST Start time of loop command ( Date/Time ) LOOP, CAL LOOP
.MA.GFL Maximum gas flow in mL/min MEAS T/Flow
.MA.MEA Maximum measured value in the units of the measured
value DET, MET, SET, KFT,
STAT, MEAS
.MA.TEM Temperature for maximum measured value in °C DET, MET, SET, KFT,
STAT, MEAS
.MA.TIM Time for reaching the maximum measured value in s DET, MET, SET, KFT,
STAT, MEAS