John Deere 318 - Manual (Page 164)

12. Apply multipurpose grease on the face of the upper
cover plate, steering shaft end and thrust bearing (B).
NOTE: Wide shoulder of spacer (A) faces up, away from
upper cover plate.
13. Install parts (A—E).
A—Thrust Bearing Spacer
B—Thrust Bearing
C—Face Seal
D—Backup-Ring (4-Port and Early 5-Port)
E—Seal Spacer
Four-Port and Early Five-Port
Later Five-Port
M36853
-UN
-29AUG88
M77305
-UN
-06MAR95
14. Put drive plate (A) on a clean surface with slot
downward.
15. Install and turn stator (B) until the stator slots (C) are
aligned with drive plate holes (D).
16. Install rotor (E) with five pin holes (F) up.
A—Drive Plate D—Drive Plate Hole (11)
B—Stator E—Rotor
C—Stator Slot (11) F—Pin Hole (5)
M36861
-UN
-29AUG88
17. Apply multipurpose grease on spacer.
18. Install spacer in rotor drive slot.
M36849
-UN
-29AUG88
MX,15906006,36 -19-10MAR95
MX,15906006,37 -19-01MAR95
MX,15906006,38 -19-01MAR95
Steering—318 and 420/Steering Valve
TM1590 (17MAY95)
60-06-14
316, 318 & 420 Lawn and Garden Tractors
020895
60
06
14