John Deere 318 - Manual (Page 259)

22. Remove input shaft assembly from cap (A).
23. Remove shims (B).
24. Remove seal (C) using a punch and hammer.
NOTE: Bearing cup is press-fit in cap. Remove bearing
cup only if replacement is necessary.
Bearing cups and cones are matched and must
be replaced as complete assemblies.
25. Inspect bearing cup (D) for wear or damage.
Replace if necessary.
26. Remove bearing cup using a brass drift or punch
and hammer.
27. Press shaft (E) from bearing cone (F).
28. Press shaft (E) from bevel gear (G) and bearing
cone (H).
29. Remove key (I).
30. Inspect all parts for wear or damage. Replace as
necessary.
Input Shaft Assembly
A—Cap
B—Shims (as required)
C—Seal
D—Bearing Cup
E—Input Shaft
F—Bearing Cone
G—Bevel Gear
H—Bearing Cone
I—Key
M77327
-UN
-24FEB95
MX,15908015,33 -19-29MAR95
Mower Gear Case Repair/260 Rotary Mower
TM1590 (17MAY95)
80-15-31
316, 318 & 420 Lawn and Garden Tractors
020895
80
15
31